Production:
This product is made by new technology, Lightning Protection Design,Only the single could make 10/100M Ethernet (Including ADSL, HFC, FTTB, +LAN connect and so on) as 10M full-duplex speed to transmission single up to 300 meters above, when used as repeater up to 600 meters, support power over Ethernet and multiple-tandem, If the two LAN-600 Ethernet extender which is tandem could make the actual distance up to 1,000 meters, one input four output, could used once plug, simple and reliable, can be easily achieved switch, HUB, Router, ADSL, Network Card. Ethernet Industrial Control Equipment, Security Equipment etc, the long distance of any combination of these interconnection, also could be used as HUB, help to quickly layout decentralized Ethernet and Internet. The basic principle is that through the signal shaping, increased sensitivity to realize the distance extension of its Voltage and waveform completely in line with the national standard of Ethernet, will not harm the network, Please be assured that used in the five or UTP unshielded cable.
Products character:
Particular LRE(Long-Reacher Ethernet,with exclusive HIC design.
Plug and play, mini size
Transmission distance:300m
Special lightningproof chip
The ethernet extender transmission distance can up to 300m.
Built-in low radiant and surge-proof power supply,super-low power consumption,super low heat.
Wide range low voltage AC power
LED indicates activith,link,confiction and power state of ports.
Votgage:12v/220v optional
High integration of hardware circuit.
Double power source hot standby,simple design of circuit,relibable performance.
Compatible with 10BASE-T
Compatible with IEEE802.3 extender unit.
Accord with EMC industry condition.
Product specification:
Size: 100*80*30
Operation temperature:-40+70
Relative humidity:10%90%
Vooltage:DC 220V
Power consumption:5w
Products information:
4ports network extender,10m,300m transmissio distance,built-in power source,200v,UTP cat5e.
Please note before installation
Please note before installation:
- cable line whether correct( It can make this device as the HUB routing )
- whether make the corresponding direct or cross network cable into correct interface
- power supply whether is normal ( Power light is normal)
- whether set the network card automatically as 10M/100M ( Turn Click: My computer- Contral panel- System- Hardware-Device Manager-Network Card Properties- Advanced-Value set)
- Check the IP address of terminal computer setting, to avoid conflict with the network
- Sometimes, it needs tens of seconds which could connect automatically
- In case of device connected and the signal indicator light, however, it is block-up. Only needs to shortened a few meters of the cable.
- Since the product is that down-side and up-side each are 350 meters to achieve the transmission of 700 meters, please be placed in the effective regulation within the maximum transmission distance should put it in the middle. (the up-side longer than the down-side length of 30 meters)
